UrgentAutomation sells surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with UrgentAutomation and not the manufacturer. UrgentAutomation is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Read More
Some of the products sold by UrgentAutomation may come with firmware installed on them. UrgentAutomation makes no representation as to your ability or right to download, obtain, or use any firmware provided by the product's manufacturer. To the extent you wish to use such firmware, it is your responsibility to comply with the terms of any applicable license or other such agreement related to the download, installation, or use of the firmware. UrgentAutomation makes no representation that the version of the firmware that is installed on any product it sells is appropriate for your needs or use. Further, UrgentAutomation does not sell, re-sell, or license software that may be needed to operate certain hardware and customers must obtain any necessary software licensing, maintenance, or upgrades from the manufacturer or other authorized source. To the extent any of the products sold by UrgentAutomation requires software for operation, you acknowledge that UrgentAutomation does not sell or license such software and that it is solely your responsibility to obtain the software or a proper license to use it from authorized sources. Read less
The Eaton Cutler-Hammer D100CR14 is a 14 I/O Micro PLC from D100 series. This is small-sized Programmable Logic Controller (PLC) equipped with 14 I/O (8 inputs + 6 outputs), high-speed counter, and the device is an analog expandable type. It is supplied with 115 Volt AC voltage. Its inputs are a 24 Volt DC type, and its outputs are relays. This module’s software supports 16 timers, 16 counters, 256 steps of step sequencers, and 128 steps of shift registers. The available memory on this device is a 1K RAM memory, which takes close to 8 milliseconds to scan, and this module is a brick-styled stand-alone device. Its installation, connection, and programming procedures are all very simple and the program can be entered via this module’s special feature, a hand-held programmer. This programmer has an LCD and a keyboard. It displays a ladder program which is easily editable.
The programmer device is plugged into the D100CR14 controller, where it receives power, but to gain access to the connector on the controller, the cover labeled “Programmer” must be pushed to the left. Then a program can be entered into the controller via a pre-programmed PROM, or by connecting to a PC and using suitable software, which has certain advantages in easy troubleshooting and reporting. The D100CR14 has only 14 I/O, but it can be expanded with a maximum of two modules to increase its I/O count to 34 in total (20 inputs + 14 outputs). This D100CR14 controller’s ambient working temperature is around 0 to 60 degrees Celsius (32 to 140 degrees Fahrenheit). The controller can be mounted either horizontally or vertically, directly to the panel, using screws or DIN rails. This PLC has dimensions of 9.3 x 6.7 x 1.6 inches (235 x 170 x 40 millimeters).