UrgentAutomation sells surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with UrgentAutomation and not the manufacturer. UrgentAutomation is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Read More
Some of the products sold by UrgentAutomation may come with firmware installed on them. UrgentAutomation makes no representation as to your ability or right to download, obtain, or use any firmware provided by the product's manufacturer. To the extent you wish to use such firmware, it is your responsibility to comply with the terms of any applicable license or other such agreement related to the download, installation, or use of the firmware. UrgentAutomation makes no representation that the version of the firmware that is installed on any product it sells is appropriate for your needs or use. Further, UrgentAutomation does not sell, re-sell, or license software that may be needed to operate certain hardware and customers must obtain any necessary software licensing, maintenance, or upgrades from the manufacturer or other authorized source. To the extent any of the products sold by UrgentAutomation requires software for operation, you acknowledge that UrgentAutomation does not sell or license such software and that it is solely your responsibility to obtain the software or a proper license to use it from authorized sources. Read less
The D100 Series of Micro PLCs from Cutler-Hammer are programmable, small-sized, fairly priced controllers that come in a variety of configurations to suit multiple of applications. Each D100 controller’s CPU has a 1K RAM (EEPROM or UV PROM) installed with 16 timers, an 8 millisecond scan time per 1K of memory, 16 counters, a 256 steps sequence, and a 128 step register. Each controller can be programmed directly through the use of a Personal Computer, or alternatively, through the use of this module’s hand-held programmer. The D100 family of controllers range in I/O from 14 I/O to 120 I/O and the basic controllers come in four varieties, which are 14 I/O, 20 I/O, 40 I/O and 40 I/O high speed.
The D100ERA40, however, is an expander, which can be used to expand the I/O in any of the above-mentioned controllers, in order to increase the number of I/O, provided that the maximum I/O capacity of the controller is not exceeded. This expander can be mounted in the same protective unit as that of the controller, with the controller mounted either at the top of the expander or to its right. Short connecting cables, which carry high-speed signals, are used to connect the D100ERA40 to the controller or to another expander. The connection cables must be flat, not twisted, and connected by the most direct and shortest possible path to equipment in question. The D100ERA40 is a 40 I/O expander with a 30-centimeter cable (for connection to the controller or the other expanders). It has 40 I/O, which are divided into twenty-four 115 Volt AC inputs and sixteen relay type outputs. This module is also powered by 115 Volts AC. The D100ERA40 can be mounted in any direction, (vertical or horizontal), directly to the panel or onto a DIN rail. Ensure that the cables are correctly connected, as failure to do so may damage to controller and or expander.