UrgentAutomation sells surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with UrgentAutomation and not the manufacturer. UrgentAutomation is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Read More
Some of the products sold by UrgentAutomation may come with firmware installed on them. UrgentAutomation makes no representation as to your ability or right to download, obtain, or use any firmware provided by the product's manufacturer. To the extent you wish to use such firmware, it is your responsibility to comply with the terms of any applicable license or other such agreement related to the download, installation, or use of the firmware. UrgentAutomation makes no representation that the version of the firmware that is installed on any product it sells is appropriate for your needs or use. Further, UrgentAutomation does not sell, re-sell, or license software that may be needed to operate certain hardware and customers must obtain any necessary software licensing, maintenance, or upgrades from the manufacturer or other authorized source. To the extent any of the products sold by UrgentAutomation requires software for operation, you acknowledge that UrgentAutomation does not sell or license such software and that it is solely your responsibility to obtain the software or a proper license to use it from authorized sources. Read less
The Eaton Cutler-Hammer EHD3100 is an EHD type of thermal-magnetic circuit breaker with non-interchangeable trip units. This is a molded case circuit breaker manufactured by Eaton Cutler-Hammer. It is a 100 Amps rated three-pole device from Series C. This module is built to work with 480 Volts AC and 250 Volts DC voltages. This circuit breaker is used in applications requiring high current switching capabilities. It has a molded case and hardware construction to react instantaneously and automatically in overcurrent situations. This molded case switch is UL-listed. The EHD3100 is a complete circuit breaker with load side terminals only. The load side terminals are used for wire connecting capabilities for specific wire ratings and wire types.
On the front side, there is a handle to put this device into a working state (on). When there is an overcurrent trip, the handle goes automatically to the “trip” position, opens the power circuit, and protects all the equipment connected behind it. After the trip situation, the user must pull the handle to the “off” and then to the “on” state. The Eaton EHD3100 has dimensions of 6.00 inches x 4.13 inches x 3.38 inches (152.4 millimeters x 104.8 millimeters x 85.7 millimeters). These dimensions correspond to the F-frame sized thermal-magnetic circuit breaker. Before installing the device, inspect it and then mount it to the panel without tightening the screws to more than 28 pounds on an inch. After that, connect the wires to the power terminals. The EHD3100’s shipping weight is approximated at 4.3 pounds (1.95 kilograms). Its normal operating temperature should not be greater than 40 degrees Celsius (104 degrees Fahrenheit).