UrgentAutomation sells surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with UrgentAutomation and not the manufacturer. UrgentAutomation is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Read More
Some of the products sold by UrgentAutomation may come with firmware installed on them. UrgentAutomation makes no representation as to your ability or right to download, obtain, or use any firmware provided by the product's manufacturer. To the extent you wish to use such firmware, it is your responsibility to comply with the terms of any applicable license or other such agreement related to the download, installation, or use of the firmware. UrgentAutomation makes no representation that the version of the firmware that is installed on any product it sells is appropriate for your needs or use. Further, UrgentAutomation does not sell, re-sell, or license software that may be needed to operate certain hardware and customers must obtain any necessary software licensing, maintenance, or upgrades from the manufacturer or other authorized source. To the extent any of the products sold by UrgentAutomation requires software for operation, you acknowledge that UrgentAutomation does not sell or license such software and that it is solely your responsibility to obtain the software or a proper license to use it from authorized sources. Read less
The Cutler-Hammer FD1010 is a Series C one-pole complete molded case circuit breaker. This is a Type FD thermal-magnetic circuit breaker with a non-interchangeable trip unit. It has a fixed thermal and a fixed magnetic trip. The current rating of this MCCB is 10 Amps. This current should be around 20% greater than the application’s current consumption or this device cannot fully protect the electronic devices it is attached to. The item can be connected to 277 Volts AC voltage or 250 Volts DC voltage. The interrupting capacity of the FD1010 depends on the voltage being used. The interrupting capacity is 35 kAIC at 277 Volts AC and 10 kAIC at 250 Volts DC. The Eaton FD1010 is usually a part of commercial and industrial panelboards, motor control centers, and switchboards.
The FD1010 has a handle in the middle of the front panel that indicates the status of the contacts. If the handle is in the “on” position, then the current is transferred from the input to the output of the MCCB. When there is a trip situation, this handle automatically goes to the “trip” position and the current flow to the output is discontinued. Users must reset this device manually or install an automated device on it as an option. The FD1010 MCCB has a length of 3.38 inches (86 millimeters), a height of 6.00 inches (152 millimeters), and a width of 1.38 inches (35 millimeters). The FD1010 thermal magnetic circuit breaker has been tested and listed by UL. It has F frame housing with a high dielectric strength to house the tripping mechanism and terminals. In case of an overcurrent or short-circuit, this device provides automatic and instantaneous circuit breaking. The item weighs 2.0 pounds (0.9 kilograms).