UrgentAutomation sells surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with UrgentAutomation and not the manufacturer. UrgentAutomation is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Read More
Some of the products sold by UrgentAutomation may come with firmware installed on them. UrgentAutomation makes no representation as to your ability or right to download, obtain, or use any firmware provided by the product's manufacturer. To the extent you wish to use such firmware, it is your responsibility to comply with the terms of any applicable license or other such agreement related to the download, installation, or use of the firmware. UrgentAutomation makes no representation that the version of the firmware that is installed on any product it sells is appropriate for your needs or use. Further, UrgentAutomation does not sell, re-sell, or license software that may be needed to operate certain hardware and customers must obtain any necessary software licensing, maintenance, or upgrades from the manufacturer or other authorized source. To the extent any of the products sold by UrgentAutomation requires software for operation, you acknowledge that UrgentAutomation does not sell or license such software and that it is solely your responsibility to obtain the software or a proper license to use it from authorized sources. Read less
The Eaton Cutler-Hammer KT2225T is a trip unit with 2 poles that can be installed in C Series molded case circuit breakers with K Frames. It is applicable for 225 Amps rated systems and it satisfies the UL-489 standard requirements. The Eaton KT2225T is an interchangeable trip unit that has a thermal element with the time delay on the overload and an adjustable magnetic trip that offers protection against short circuits. The KT2225T trip unit is calibrated at 40 degrees Celsius and its housing is factory sealed to disable the tampering option. This calibrated nominal device current that the trip unit can carry continuously is marked on the nameplate of the trip unit. Note that according to the NEC requirements, protective devices like molded case circuit breakers should not be loaded with more than 80% of the nominal current rating.
The users should not connect cables to the MCCB or supply it with the power until they install the KT2225T into it. Inspect the trip unit for visible signs of damage before integrating it with the circuit breaker frame. On the load side of the frame, remove the plastic protective covers and push the trip unit upwards until the trip unit is correctly seated in the base. Check the latch bracket pin. It should be properly placed in its slots. To position the trip unit easily, the users can push the circuit breaker lever to the closed position. To finish the installation process, use a hexagonal-head wrench to screw in and tighten the retaining screws of the trip unit (the screws on both poles). Put protective plastic barriers on the trip unit.