Urgent Automation is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply.
Product comes with Urgent Automation's 1-year warranty.
Rockwell Disclaimer: The product is used surplus. Urgent Automation is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because Urgent Automation is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, Urgent Automation makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Urgent Automation also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. Urgent Automation also makes no representations as to your right to install any such firmware on the product. Urgent Automation will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
Urgent Automation is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply.
Product comes with Urgent Automation's 1-year warranty.
The D100ERC8 is an 8 I/O expansion module from a D100 series of the Micro PLCs manufactured by Eaton Cutler-Hammer. The D100ERC8 expansion module requires 115 Volts of AC for its I/O. Four inputs are 24 Volt DC rated while four outputs are relays for 24 Volts DC or 240 Volts AC (2A contacts at 240 Volts AC). This module’s outputs are set on the lower side of the module, while its inputs are on the upper side. Every input/output state is visualized over signaling lamp. The D100ERC8 is delivered with an 80-millimeter long cable. The Cutler-Hammer D100 series is engineered as small-size PLC platform. When there is a need for a greater number of input/output points, the D100ERC8 expansion chassis comes handy in expanding PLCs capabilities. Any D100 series micro PLC can have a maximum of 2 expanding modules. Expansion units are connected by a cable to the controller to provide additional inputs and outputs. If there is an analog module in the system, it must be connected to the controller before a digital expansion module like D100ERC8. Addresses on this I/O expansion module continue from addresses from the controller that it is attached to, or from addresses from previous expansion module. The addresses are numbered in octal number sequence.
The D100ERC8 has operating temperature range 0 to 60 degrees Celsius (32 to 140 degrees Fahrenheit). Its approximate weight is 1 pound (0.5 kilograms). The dimensions of the expansion module are 5.32 x 4.00 x 4.4 inches (135 x 100 x 112 millimeters). The recommended clearance all around the module for wiring space and heat dissipation is 4 inches (100 millimeters). The device can be directly mounted to the panel or onto a DIN rail and the connecting cable between units should go by the most direct path possible. Do not twist the cable, it must remain flat.
Manufacturer | Eaton Cutler-Hammer |
Brand | Eaton Cutler-Hammer |
Part Number/Catalog No. | D100ERC8 |
Product Type | 8 I/O Expander |
Power Supply | 115V AC |
Inputs | 4 |
Input Type | 24V DC |
Outputs | 4 |
Output Type | Relay |
Manufacturer | Eaton Cutler-Hammer |
Brand | Eaton Cutler-Hammer |
Part Number/Catalog No. | D100ERC8 |
Product Type | 8 I/O Expander |
Power Supply | 115V AC |
Inputs | 4 |
Input Type | 24V DC |
Outputs | 4 |
Output Type | Relay |